Page 1 of 1

Author:  DaveC [ Fri Dec 16, 2016 4:15 pm ]
Post subject:  1275GT

I have been doing some work on my 1275GT recently with the aim of bringing it to the IMM.


It needed a new clutch master and slave cylinder. The old ones had seen better days with an oval hole in the actuating rod, grooved clevis pin and old split pin, and they were seized


I also ordered a load of panels which arrived in 3 boxes the other day, mainly sills, a panels, bootlid hinge panel, all the usual stuff


The plan is to sort the bodywork next.
If it isn't finished for the IMM then I will be going in the back up Mini 1000

Author:  The Marcos Graveyard [ Fri Dec 16, 2016 7:51 pm ]
Post subject:  Re: 1275GT

Great wheels move slowly Dave.

Will be following with interest.


Author:  Billy [ Mon Dec 19, 2016 12:22 pm ]
Post subject:  Re: 1275GT

Great to see the push on, Dave. It will probably be finished before my Clubby.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited