irishminis.ie

Welcome to the Irish Mini Owners Club forum. Celebrating 30 years of the Irish Mini Owners Club, 60 years of the Mini, 50 years of the Clubman and 20 years of our flagship event MTM
It is currently Tue Jun 18, 2019 8:16 pm

All times are UTC+01:00


*** Important Notice – The Irish Mini Owners Club website is moving. This Thursday the IMOC forum will be disabled to allow the migration of data to the new hosting provider. ***


Post new topic  Reply to topic  [ 2 posts ] 
Author Message
 Post subject: CV Joint seating washer
PostPosted: Thu Jun 13, 2019 10:23 am 
Offline
NON Member

Joined: Sun May 15, 2011 10:56 pm
Posts: 41
Whats your location?: Dublin
Region: Eastern
Hi All.
Would anybody know the dimensions of the seating washer to torque up the cv joint/front wheel bearing (tool21 on minispares).

Or even better, does anybody have one that they could lend me for a day?

Thanks
Ciaran


Top
PostPosted: Sat Jun 15, 2019 3:49 pm 
Offline
IMOC Paid Member
User avatar

Joined: Mon May 09, 2005 9:28 pm
Posts: 23
Location: Dublin
There is a drawing & description in your Haynes Manual in the chapter on 'Driveshafts'. It is cut from 1/4in. - 6.5mm sheet steel or a washer with a Diameter of 50mm & a centre hole of 25mm. Don't use anything thinner as you will not be able to pull the CV joint tight. Eamonn.


Top
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited